DJI Z15-5D III (HD) - Manual (Page 17)

Zenmuse Z15-5D III (HD) User Manual
©2014 DJI. All Rights Reserved.
17
Orientation-locked MODE channel end-point 60%~90%
FPV (Reset) back to center
Non orientation-locked MODE channel end-point 60%~90%
The gimbal will work in Orientation-locked mode if the MODE channel is disconnected.
FPV mode is the default startup mode when the MODE channel is connected.
The Working Mode from the previous power cycle will be retained if the cable between MODE and
the RC receiver is disconnected during operation.
For a 3-position switch, you may assign:
Position-1 to Non orientation-locked
2-Positon
Switch
3-Positon
Switch
3-Positon
Switch
Position-2 to FPV Mode (Reset)
Position-3 to Orientation-locked
Position-1 and Position-3 can be inversely assigned.
One 2-position switch can be assigned for any two of the working modes, if preferred.
AUX1 Switch Settings
The Z15-5D III (HD) gimbal has a 360° panoramic photograph function. Choose a 2-position switch as
AUX1 switch for this function and wire the relevant channel of the receiver to the AUX1 port. Toggle the
switch once to turn on the function and toggle again to turn off the function.
2-Positon
Switch
3-Positon
Switch
3-Positon
Switch
AUX2 Switch Settings
The Z15-5D III (HD) supports toggling the camera lens down or forward in FPV Mode (Reset). Please
choose a 2-position switch for this function and wire the relevant channel of the receiver to the AUX2 port.
You may assign: Position-1 to DOWN; Position-2 to FORWARD; or reverse the assignment.
2-Positon
Switch
3-Positon
Switch
3-Positon
Switch
This function will only work in FPV Mode (Reset).
When this function is active, if the Working Mode is ever changed to FPV Mode (Reset), the gimbal
will force the camera lens to face forward or down, depending on current the location of the AUX2
switch.
The camera orientation is forward if AUX2 is disconnected.
If AUX2 is connected to a Futaba S-Bus channel, it is then used as the input channel for S-Bus
control.
Working Mode /AUX1/AUX2/AUX3 Switch Setup