Scenario 7 – phantom 2 with 2.4ghz remote control, Scenario 8 – phantom 2 with 5.8ghz remote control – DJI Lightbridge User Manual User Manual
Page 24
©2014 DJI. All Rights Reserved.
24
Scenario 7 – Phantom 2 with 2.4GHz Remote Control
1.
Connect HDMI IN port to HDMI out port on camera with HDMI cable.
2.
Connect Gimbal Port to EXP port (6-pin port) on DJI Phantom 2 central board with Gimbal cable. To
access the EXP port, you will need to remove the top of the DJI Phantom 2 case. See below example
for details.
3.
Connect DBUS port on air system with X2 port on the flight controller.
Note
：
1.
Linking is required when using with PPM 2.4GHz receiver.
Scenario 8 – Phantom 2 with 5.8GHz Remote Control
1.
Connect HDMI IN port to HDMI out port on camera with HDMI cable.
2.
Connect Gimbal Port to EXP port (6-pin port) on DJI Phantom 2 central board with Gimbal cable. To
access the EXP port, you will need to remove the top of the DJI Phantom 2 case. See below example
for details.
Note
：
1.
Aircraft will need to be modified to accommodate 5.8GHz receiver.
X2
HDMI
EXP