DJI Lightbridge User Manual User Manual
Page 33
©2014 DJI. All Rights Reserved.
33
1
） Display HDMI OSD: Enable or disable the OSD display on your HDMI device.
2
） OSD Margin: Adjust the OSD position to fit HDMI displays of different sizes.
3
） 720P Refresh Rate: Set the refresh rate to 50Hz or 60Hz in Realtime or Smooth mode.
4
） 1080I Refresh Rate: Set the refresh rate to 50Hz or 60Hz in Full HD mode.
Note
The OSD is not available when AV video input is selected.
[6]
Warning Settings
1
） Alarm: Enable or disable the alarm.
If enabled, the app will set off an alarm in the following scenarios:
a
） The aircraft battery is low.
b
） The remote control’s transmission signal has been lost.
2
） Ground system timeout: Enable or disable ground system timeout. When enabled, if the ground
system is idle for 30 minutes, an alarm will sound and the system will power off.
[7]
Signal Diagnostic
If the maximum flight distance is significantly reduced, this could be caused by damaged antennas or a