Braun MILLENIUM 5 - Manual (Page 8)

Page 6
Platform Angle Adjustment
Wedges
Angle $
equals
Angle %.

%
Figure C
$
Approximately
1” Clearance
Figure D
Millennium “NL” Series
Century “NCL” Series
9LVWD´19/µ6HULHV
Inboard Outboard
Inboard Outboard
Wedges
Toe must
angle
down
slightly.
Barrier
must
unfold
fully.
Adjusting the platform angle based on the
relationship of the platform at ground level
directly affects the angle of the platform
ZKHQSRVLWLRQHGDWÁRRUOHYHO
Unfold the lift and visually examine the
angle of the platform when positioned at
ÁRRUOHYHO/RZHUWKHSODWIRUPIXOO\DQG
note the angle of the platform when it
reaches ground level also. The outboard
HQGRIWKHSODWIRUP (toe) must contact
the ground
ÀUVW when the platform is
lowered (all lift models).
Millennium “NL” Series:
The platform angle should be adjusted so
there is a balance between the angle at
both positions (equal amount of angle).
$QJOH$ should HTXDODQJOH%as shown
LQ)LJXUH&
Century “NCL” Series:
9LVWD´19/µ6HULHV
The platform angle must be adjusted so
the outboard end of the platform (toe) is
angled down slightly when positioned at
ÁRRUOHYHO6HH)LJXUH'7KHRXWERDUG
end of the platform must contact the
JURXQGÀUVWWRensure the spring-loaded
outer barrier unfolds fully.
$GMXVWPHQW3URFHGXUHV Adjustment
Allen screws are provided on each side of
the lift platform for adjusting the platform
DQJOH'HWDLOVDQGSKRWRVDUHSURYLGHG
on the opposite page.
%DVH3ODWH:HGJHV  Installations where
base plate wedges are used require more
platform angle adjustment than normal.
3ODWIRUP6WRS%ORFNV When ad-
justing platform angle, ensure both
VWRSEORFNVDUHPDNLQJIXOOFRQWDFW
ZLWKWKHYHUWLFDODUPV (details on
opposite page).
)ORRU/HYHO$GMXVWPHQW )ROORZ-
ing platform angle adjustment, set
ÁRRUOHYHOSRVLWLRQLQJDVGHWDLOHGLQ
3ODWIRUP)ORRU/HYHO$GMXVWPHQW
(details on page 8).