Belkin ePowerSwitch - Manual (Page 33)

29
9. User enter 888XXX…..# or whatever previous password,
then ePowerSwitch responds with three short beeps
acknowledge access granted. Then user enter new
password as following:
888XXXXXXXXXX#, and ePowerSwitch acknowledge 2
short beeps, sounds like “what?” and user input
888XXXXXXXXXX# the second time to re-confirm, and
ePowerSwitch acknowledge 4 short beeps, indicating
password change completed.
10. Hang up to close access.
11. Each command string should be entered within 20 seconds,
the ePowerSwitch in a waiting loop to receive command.
After 180 seconds without user input, the device will logout
user.
12. “000#” key force to logout.
13. *” key cancel keyin error .
14. User interface use minutes as unit.