Black & Decker NPT318 User Manual

Page 8

Advertising
background image

8

Switch

Always be sure of your footing and grip the
Pole Trimmer firmly with both hands with
the thumb and fingers encircling the
handle. To turn the tool ON pull the lock
button (1) back with your thumb and then
squeeze the trigger (2) with your fingers as
shown in figure 14. (Once the tool is
running you can release the lock button.)
To turn the tool OFF, release the trigger.

Trimming Instructions

1. WORKING POSITION - Maintain proper footing and balance

and do not overreach. Wear safety goggles, non-skid footwear
and gloves when trimming. Hold the tool firmly in both hands
and turn the tool ON. Always hold the trimmer, as shown in the
illustrations in this manual, with one hand on the switch handle
and one hand on the pole. Never hold the tool by the hand guard.

2. TRIMMING NEW GROWTH - A wide, sweeping motion, feeding

the blade teeth through the twigs is most effective. A slight
downward tilt of the blade, in the direction of motion gives the
best cutting. Do not cut stems greater than 3/8” (10mm). Use the
trimmer only for cutting normal shrubbery around houses and
buildings.

3. LEVEL HEDGES - To obtain exceptionally level hedges

a piece of string can be stretched along the length of the hedge
as a guide.

4. SIDE-TRIMMING HEDGES - Begin at the bottom and sweep up.

WARNING: TO GUARD AGAINST INJURY, OBSERVE THE

FOLLOWING:

READ AND UNDERSTAND INSTRUCTION MANUAL BEFORE

USING.

SAVE INSTRUCTION MANUAL.
KEEP HANDS AWAY FROM BLADES.
KEEP HANDS ON HANDLE AND POLE. DON’T OVERREACH.
BLADE COASTS AFTER TURN OFF.
DO NOT USE UNDER WET CONDITIONS.

14

Troubleshooting Section

If your Pole Trimmer does not operate correctly check the following:
Problem

Possible Cause

Possible Solution

• Tool will not

start.

• Battery will not

charge.

• Battery not

installed properly.

• Battery not

charged.

• Lock-out button not

actuated.

• Pole connections

not properly
tightened.

• Battery not

inserted into
charger.

.

• Check battery installation.

• Check battery charging

requirements.

• Pull back on lock

button/actuate trigger.

• Refer to instruction manual

for pole connections.

• Insert battery into charger

until red LED appears.
Charge up to 9 hours if
battery totally drained.

629050-00 NPT318 Pole Trimmer 12/14/04 2:12 PM Page 8

Advertising