Bissell 92L3 - Manual (Page 16)

16
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
T
roubleshooting
Vacuum cleaner won’t run
Possible causes Remedies
1. Power cord not plugged in 1. Check electrical plug
2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker
WARNING:
To reduce the risk of electric shock,
turn power OFF and disconnect
polarized plug from electrical outlet
before performing maintenance or
troubleshooting.
M
aintenance and care
Cleaning the upper tank
1. Grasp the inner cyclone and twist to the left
until the locking tabs stop the rotation. Pull
down from the upper tank to remove it.
2. Wipe out the inside of the upper tank and the
inner cyclone with a damp cloth moistened
with water or a mild cleaning solution.
3. If you desire to thoroughly clean the filtration
disk located in the upper portion of the inner
cyclone, hold the bottom of the cyclone and
turn filtration disk to the right and pull up to
remove.
4. The inner cyclone and filtration disk may be
washed using a mild detergent. Be sure it
is completely dry before reassembling or
damage to your unit may result.
5. Once cleaning is completed, reassemble the
filtration disk over the inner cyclone by
sliding it straight down on the top of the
inner cyclone and turning left. Be sure to line
up the tabs when reassembling for proper
installation.
6. To replace the inner cyclone, slide it into the
upper housing. Be sure to line up the inner
cyclone by ensuring tabs on filtration disk
are positioned toward the front of the unit.
Push the inner cyclone in and rotate it to the
right until the locking tabs stop the rotation.
1.
3.
5.
6.
ug110-4054_92L3_608.indd 16 ug110-4054_92L3_608.indd 16 8/8/08 2:36:47 PM 8/8/08 2:36:47 PM