Bissell 92L3 - Manual (Page 6)

Attach vacuum hose and tools
1. Attach the Twist ‘n Snap™ Hose by lining up
the tabs on the base with the corresponding
notches on the back of the vacuum as shown.
2. Turn the Twist ‘n Snap Hose to the right to
lock the hose into place.
3. Grasping the Quick Reach Handle, slide the
end of the Hose Wand onto the Hose Wand
Base. Snap the Hose into the Hose Clip.
NOTE: The vacuum will not operate effectively
unless the hose wand is firmly attached.
4. Slide the extension wand and crevice tool
into the storage clip on back of vacuum.
5. Slide the dusting brush/upholstery tool into
the storage clip on back of vacuum.
6. Attach the Contour Tool to the back
of the vacuum by inserting tool into
storage clip.
7. Store the TurboBrush on the front of the
handle by lining up the TurboBrush base
with the base of the holder then push back
to snap into place.
Power switch
The Power Switch is located on the left side of
the vacuum. Push the rocker switch “ON” (I)
to vacuum, and “OFF” (O) when cleaning is
complete.
A
ssembly
6
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
NOTICE:
For above floor cleaning, the floor
brush will continue to rotate, but
is raised above floor. To prevent
carpet damage, do not lean on
the vacuum or let the powerfoot
tilt forward.
CAUTION:
To avoid personal injury
and to prevent the cleaner
from falling when cleaning
stairs, always place it at
the bottom of the stairs.
O
perations
CAUTION:
Before using your vacuum,
make sure that the dirt
container is in the locked
position and that all filters
(pre-motor and HEPA media
post-motor) are in place.
Do not operate your vacuum
without these filters.
1.
Twist 'n
Snap Hose
7.
3.
ug110-4054_92L3_608.indd 6 ug110-4054_92L3_608.indd 6 8/8/08 2:36:31 PM 8/8/08 2:36:31 PM