E-flite Brio 10 ARF - Manual (Page 16)

  3. Slide the aileron into position. Check to
make sure it can move without interference at
the wing root and wing tip. Remove the T-pins
and apply Thin CA to each hinge. Make sure
the hinge is fully saturated with CA. Use a paper
towel to clean up any excess CA from the wing
and aileron. Make sure to apply CA to both sides
of the hinge.
  2. Slide three hinges into the slits in the aileron.
Center the slot in the hinge with the hole drilled
in Step 1. Place a T-pin in each hinge to prevent
it from being pushed into the wing when
installing the aileron.
Note: Do not use CA accelerator during the
hinging process. The CA must be allowed to
soak into the hinge to provide the best bond.
Using accelerator will not provide enough time
for this process.
16