E-flite Fokker DVII 250 ARF User Manual
Page 20
20
E-flite Fokker DVII 250 Slow Flyer Assembly Manual
11. The rigging now heads to the rear hole in the
outer strut. Again, this line will be in front of the
current rigging lines.
12. Route the rigging up and to the forward hole in
the outer strut.
13. The rigging now goes down and through the
forward tube in the fuselage. This line will be in
front of all the other rigging lines.
14. After exiting the fuselage, route the rigging up
to the forward hole in the outer strut. Make sure
the rigging is in front of all the previously installed
rigging lines.
15. This completes the second stage of rigging. Use
low-tack tape to secure the tape on the underside
of the bottom wing. The end taped will be secured
once the rigging is ready to be tensioned.