E-flite C-Ray 180 PNP - Manual (Page 8)

8
EN
Transmitter and Model Setup
Transmitter Setup
Flying wings are controlled by elevons (the
moveable surfaces on the C-Ray wing). Elevons
combine aileron and elevator controls and mix them
together electronically through the transmitter.
Make sure both elevons move up and down (travel)
the same amount. This model tracks well when
the left and right elevon travel the same amount
in response to the control stick. See the Control
Centering instructions for centering the control
surfaces.
Measuring Control Throws
Below is the location on this aircraft to measure
the recommended low and high rate control throws
(distance) in both directions.
Elevons:
From the center line guide (A) defl ect the trailing
edge of the elevon (B).
Expo
High Low
Aileron 10% 0%
Elevator 10% 0%
When using a DX6i transmitter, servo
reversing on the elevator channel
is required.
When using a DX7s, DX8 or DX18 transmitter,
set the transmitter wing confi guration to
Elevon-B.
A
B
Dual Rates
High Low
Aileron 7mm / 5mm /
Elevator 7mm / 5mm /