E-flite Edge 540 BP 3D ARF User Manual
Page 19
1
E-flite Edge 540 BP ARF Assembly Manual
2. The elevator servo is installed in the upper hole in the
fuselage using the hardware provided with your servo. Pre-
drill the holes for the servo mounting screws using a drill and
1
/
16
-inch (1.5mm) drill bit. The output of the servo will be on
the left side facing the rear of the plane.
Note: Notch the fuselage so you can pass the elevator
servo lead to the same side of the fuselage as the aileron
servo leads.
3. The rudder servo is installed in the lower hole using the
hardware provided with your servo. Pre-drill the holes for the
servo mounting screws using a drill and
1
/
16
-inch (1.5mm)
drill bit. The output for the rudder servo will be opposite the
elevator servo facing the rear of the plane.