E-flite Apprentice S 15e RTF with SAFE - Manual (Page 8)

EN
You control the help SAFE™ technology provides while you learn to fly.
As your flying skills grow, decrease SAFE technology assistance. Change
aircraft response at any time by moving the Channel 5 (SAFE Flight mode)
switch on your transmitter.
IMPORTANT: These instructions are for the included DX5e transmitter
(or similar transmitters) with a 3-position switch for Channel 5. If you fly this
aircraft with a Spektrum transmitter other than the included DX5e, refer to
Optional Transmitter Setup and Receiver Setup.
Panic Recovery Mode
If you get into distress while flying in any mode, pull and hold the Trainer
(Panic) Switch and move the control sticks to their neutral position. The
SAFE technology will return the aircraft to a stable attitude, if the aircraft is
at a sufficient height with no obstacles in its path. Release the Panic Switch
to turn off Panic mode and return the current SAFE flight mode. If you get
into trouble and need to go back to Beginner mode for maximum stability,
remember to fully move back the Channel 5 switch.
Activating SAFE Technology
SAFE technology is not active until you advance the throttle past 25%.
Once the SAFE technology is active, the control surfaces may move on the
aircraft. This is normal. The SAFE technology will remain active until the ESC
is turned off.
Understanding Oscillation
In some flight conditions, you may see oscillation. If oscillation
occurs, decrease the airspeed. If oscillation still persists, refer to the
Troubleshooting Guide for more information.
CAUTION: Flying in level forward flight and calm wind conditions
at full throttle in any mode or long high-speed dives may result in strong
oscillation that can damage the aircraft.
If there is oscillation in any mode, decrease throttle immediately. If
oscillation persists, refer to the Troubleshooting Guide.
CAUTION: Beginner, Intermediate, and Panic modes are intended
for the training environment. Flying continuous high-G maneuvers (such
as loops) in Experienced mode for an extended period of time may lead to
inconsistent flight envelope and Panic mode behavior. If this occurs, land in
Experienced mode and power cycle the receiver before flying again.
Launch and Landing Assistance
Take off and landings can be better managed by using the Beginner mode.
If the model is launched incorrectly, or is landing at a less than perfect
attitude, pull and hold the Panic Switch. The model can correct and help to
prevent a crash.
See the Take Off and Landing sections in this manual.
IMPORTANT: A level runway is required for takeoffs in Beginner mode due
to throttle climb assistance.
Failsafe
In the unlikely loss of radio connection, failsafe will turn the aircraft in a
descending circle to the ground, unless the radio connection is restored.
Sensor Assisted Flight Envelope (SAFE) Technology
0 1 2
Front
Front
Back
Back Channel 5 Switch
(SAFE Flight Mode)
Trainer/ Panic Switch
SAFE
Take Off
SAFE
Landing
SAFE Technology makes this aircraft a better learning tool,
but you must set yourself up for success in flying:
• SAFE technology is designed as flight assistance, not an autopilot. The pilot
is always in control and required to fly the aircraft at all times
• Follow the instructions provided in this manual to maintain your aircraft in
top flying condition
• Seek qualified model flying instruction through your local model flying club. A
qualified flight instructor can propel your advancement in this hobby
• Wind and environment can affect SAFE technology flight performance
• Ensure you have no distractions so you benefit from every moment of flight time
• You must still fly the aircraft away from obstacles and at an altitude that will
allow for a safe recovery
SAFE Flight Modes Channel 5 Switch Position
Beginner Mode Position 0
Intermediate Mode Position 1
Experienced Mode Position 2
OFF ON
8