E-flite Fury 15 DF BNF Basic - Manual (Page 5)

EN
Landing Gear Installation
Tip: For belly landing, do not install the main landing gear and see the Nose
Gear Removal section to remove the nose gear from the fuselage.
Main Gear Installation
1. Install each main landing gear strut (A) in a wing mount. The coils on the
struts should be facing rearward as shown.
A
2 X 8mm (2)
3 X 12mm (2)
Horizontal Tail Installation
1. Slide the horizontal tail (A) into the slot in the rear of the fuselage
while connecting the left and right elevator servos to the marked
connectors in the fuselage.
IMPORTANT: Ensure the left elevator servo connects to port 5 and the right
elevator servo connects to port 3 on the receiver.
CAUTION: DO NOT crush or otherwise damage wiring when attaching
the horizontal tail to the fuselage.
2. Install 4 screws in the tail, above and below the elevators.
When needed, disassemble in reverse order.
A
5