E-flite Fury 15 DF BNF Basic - Manual (Page 7)

EN
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
Horns Arms
Elevator
Rudder
Ailerons
Transmitter Setup
IMPORTANT: Set up your transmitter before binding your transmitter to the
aircraft.
Transmitters DX6i and Above
Start all transmitter programming with a blank ACRO model (do a model
reset), then name the model. Leave all settings at default.
Dual Rates and Expo
Dual Rates and Expo are factory set in the receiver. GEAR / Channel 5 operates
2 fl ight modes: Position 1 is Low Rate, and Position 0 is High Rate.
Take fi rst fl ights in Low Rate fl ight mode.
NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting Guide
for more information.
7