E-flite Adagio 280 BNF Basic - Manual (Page 6)

6
EN
Binding is the process of programming the receiver
to recognize the GUID (Globally Unique Identifi er)
code of a single specifi c transmitter. You need
to ‘bind’ your chosen Spektrum
™ DSM2/DSMX
technology equipped aircraft transmitter to the
receiver for proper operation.
Any full range Spektrum DSM2/DSMX transmitter
can bind to the DSM2/DSMX receiver. Please visit
www.bindnfl y.com for a complete list of compatible
transmitters.
Important: Before binding a non-computerized
transmitter, ensure all servo reversing is set to
normal and trim is at center. Before binding a
computerized transmitter, choose a blank model
memory with only default (zero) settings. Select 1
aileron, 1 fl ap for the wing type.
Failure to do so could affect fl ight performance.
9
Binding Procedure
1. Refer to your transmitter’s unique instructions
for binding to a receiver (location of
transmitter’s Bind control).
2. Make sure the fl ight battery is disconnected
from the aircraft.
3. Power off the transmitter.
4. Bind the AR6335 receiver to a DSM2/DSMX
transmitter by inserting a bind plug in the bind
port of the receiver.
5. Connect the fl ight battery to the aircraft.
The receiver LED will begin to fl ash rapidly
(typically after 5 seconds).
6. Ensure that control surface trims are centered
and the throttle and throttle trims are in the
low position to correctly set the failsafe.
7. Put your transmitter into bind mode. Refer to
your transmitter’s manual for binding button or
switch instructions.
8. Keep the aircraft immobile out of the wind and,
after 5 to 10 seconds, the receiver status LED
will become solid, indicating that the receiver
is bound to the transmitter. If the LED does not
turn solid, refer to the Troubleshooting Guide at
the back of the manual.
9. Remove the bind plug from the receiver and
store it in a safe place. If the plug is diffi cult to
remove, carefully use pliers or a screwdriver to
overcome the friction fi t.
For subsequent fl ights, power on the transmitter
before connecting the fl ight battery.
CAUTION: When using a Futaba transmitter
with a Spektrum DSM ® module, you must reverse
the throttle channel and rebind. Refer to your
Spektrum module manual for binding and failsafe
instructions. Refer to your Futaba transmitter
manual for instructions on reversing the throttle
channel.
Transmitter and Receiver Binding
BIND PLUG