Operating instructions – E-flite BL400 Ducted Fan Outrunner, 3500Kv (Twin Pack) User Manual
Page 2
Examples of Airplane Setups:
E-flite Super Airliner ARF (EFL7000)
Comments – Sport and aerobatic performance with good climb power and top speed. This
aircraft uses two (2) Ducted Fan units for power.
Weight w/Battery: 52 oz (1470g)
Prop: 66mm Ducted Fan Unit 3 Blade Impellor
Battery: 2100mAh 3-Cell 11.1V Li-Po (THP21003SPL) (2)
ESC: 20A Brushless (EFLA311B) (2)
Accessories:
for our complete line of
brushless motors. We have posted a specification comparison sheet on our web site so you
can compare the different motors we offer.
EFLA110
Power Meter (measures power output in amps, volts, watts, and capacity)
EFLA311B 20-Amp
Brushless ESC (V2)
EFLA241
Gold Bullet Connector Set, 3.5mm (3)
Operating Instructions:
1. This brushless motor requires the use of a sensorless brushless speed control.
Failure to use the correct speed control may result in damage to the motor and/or
speed control.
2. When mounting the motor, be sure the correct length of screws are used so damage
to the inside of the motor will not occur. The use of long screws will damage the
motor.
3. You may connect the three motor wires directly to the controller with solder or use
connectors such as gold plated brushless bullet connectors (EFLA241), which will also
need to be soldered properly to your wires. The three motor wires can be connected
in any order to the three output wires or output port on a sensorless brushless speed
control. Be sure to use heat shrink tubing to properly insulate the wires so the wires
will not short. Shorting may damage the motor and speed control.
4. If you add connectors and you no longer wish to use them, never cut the motor wires.
Remove them by properly desoldering them. Shortening the motor wires is
considered an improper modification of the motor and may cause the motor to fail.
5. When you connect the motor to the esc, check the rotation direction of the motor. If
you find the rotation is reversed, switching any two motor wires will reverse the
direction so the motor rotates properly.
6. Proper cooling of the motor is very important during operation. New technology has
brought much higher capacity batteries with higher discharge rates, which can cause
extreme motor temperatures during operation. It is the responsibility of the user to
monitor the temperature and prevent overheating. Overheating of the motor is not
covered under any warranty.
7. You can install the propeller on the motor shaft after you have confirmed proper
rotation direction. Also consult the instruction included with your sensorless electronic
speed control for proper adjustments and timing.
8. Once the battery is connected to the motor, please use extreme caution. Stay clear of
the rotating propeller since spinning propellers are very dangerous as the motors
produce high amounts of torque.
9. Never disassemble the motor. This will void any warranty.