GBC MS5 - Manual (Page 16)

F.300-B/MS-5 DRILL/JULY 2000
16
WARNING: DISCONNECT THE POWER AND LOCK IT OUT whenever working on the machine
unless the instructions specifically require the machine to be powered (see Power Lockout
Procedure,
page 4 ). Several of the following tests may require the machine to be operational
for checking and adjusting. Be very careful that tools and other people are clear of moving parts, and
that the drill is not accidentally operated while adjustments are being made.
CAUTION: Whenever repairing hydraulic components, loosen connections slowly to bleed
off any trapped pressure.
Problem Area to Check Solution
1. No power Power to machine Connect Power
Main Disconnect Switch Turn to ON position
Interlocking Guards Replace guards
Fuse blown Replace fuse - see fig. 2 page 7
2. Lack of power Relief valve in pump may be bad Clean or replace relief valve or pump.
or have dirt in it.
Check oil level - may be low. Add oil.
Check voltage at machine - may Remove other machinery on line or
be low. provide a dedicated line.
3. Spindle motor stalls Dull drills. Sharpen drills.
Check for low voltage. (See above).
Check drive pulley and belt for (See SETUP INSTRUCTIONS in main
tightness. section for adjustment).
Check for paper plugging drills Clean out hollow drills - We recom-
mend cleaning and soaking drills in
oil overnight.
4. Table stroke won’t adjust Stroke Adjustment Chain off Remove back panel and replace
sprockets. chain (fig. 10).
TROUBLESHOOTING
(fig. 10)
Table Lift Rod