GBC 61 Plackmatic Bookmaker - Manual (Page 22)

22
OPERATOR MANUAL BM 61 T10165
4.3.2 Reset to standard paper sizes
Disconnect the Booklet Maker from the Collator by pressing the Docking Bracket
(green marked side).
Loosen the knob for adjustment to odd paper sizes.
Slide the Docking Bracket back to align it with the chassis in the Booklet Maker, it will
lock into place.
1.
2.
.
4.3 Paper settings
4.3.1 Set up for non-standard paper sizes
This procedure is to enable ON-line operation with paper sizes that deviate from the
standard A4/A and 8 1 /
2
“x11”/11”x17” sizes.
Perform the setup of the Booklet Maker for the paper size.
Attach the Booklet Maker to the Collator, using the positioning holes on the Booklet
Maker that best matches the paper size. (Green mark on rear side jogger as close as
possible to the Docking Bracket).
Loosen the knob for adjustment to odd paper sizes on the Docking Bracket.
Move the Booklet Maker sidewise until the green mark on the rear side jogger is
aligned with the green mark on the Collator.
Tighten the knob.
1.
2.
.
4.
5.