GBC 640T Laminator - Manual (Page 6)

640t – Installation and Operating Instructions
Page 1-2
e
lectrical
The laminator should be connected only to a source
of power as indicated in these instructions and on
the serial plate located on the rear of the laminator.
Contact an electrician should the attachment
plug provided with the laminator not match the
receptacles at your location.
WARNING: Do not attempt to service or repair
the laminator. Failure to observe this warning could
result in severe personal injury or death.
Disconnect the plug from the receptacle and contact
your dealer or distributor when one or more of the
following has occurred.
The power supply cord or attachment plug is •
damaged.
Liquid has been spilled into the laminator.
•
The laminator is malfunctioning after being •
mishandled.
The laminator does not operate as described
•
in these instructions.
CAUTION: The receptacle must be located
near the equipment and easily accessible.
Disconnect the attachment plug from the receptacle
to which it is connected and keep the power supply
cord in your possession while moving the laminator.