GunVault GVB 3000 - Manual (Page 6)

- 5 -
ENROLLING ADDITIONAL USERS
Press the Learn Button. You will hear one beep and the LED will turn green
indicating the enrollment procedure has started.
Swipe the administrator fingerprint from Position 1 to Position 2 (Figure C)
and you will hear two beeps indicating the additional fingerprint is ready for
enrollment.
Place the new finger to enroll over the scanner with the tip of your finger at
the top of the finger guide as shown in Figure B.
Make sure you have good, flat contact with the scanner. Begin to swipe the
new finger from Position 1 to Position 2 (Figure C), taking 1 to 2 seconds
to complete the swipe. Try to get your entire fingerprint to cross the
scanner.
Once the swipe is completed you will hear a beep. Repeat Step 3 one
more time. After swiping your finger 2 times the unit will beep twice, this
indicates a successful enrollment. If the swipe fails, the LED will flash red
and the unit will wait for another swipe.
ACCESSING THE UNIT
NOTE: The DrawerVault Biometric can be accessed either by valid fingerprint or
via the keys provided.
Fingerprint Access
Press and release the Start Button, the green LED flashes two times and
the unit beeps once.
Place your finger over the scanner with the tip of your finger at the top of
the finger guide as shown in Figure B.
Make sure you have good, flat contact with the scanner. Begin to swipe
your finger from Position 1 to Position 2 (Figure C), it will take 1 to 2
seconds to complete the swipe. Try to get your entire fingerprint to cross
the scanner.
If the unit detects a match, the LED will flash green two times and you will
hear two beeps, then the unit is open.
If the unit doesn’t detect a match, the LED will flash green and red, you will
be denied access. If an enrolled user is denied access, please try again. If
the problem persists, please delete all users and re-enroll again.