Human Touch PC-410 Perfect Chair - Manual (Page 5)

7
humantouch.com
6
take a seat
Using your Human Touch Perfect Chair is easy. Just take a seat and
adjust the chair to the desired position. The Perfect Chair cradles you
in zero-gravity comfort, with your feet above your heart—the ultimate
neutral-posture position for back and spine relief.
Adjust the headrest
While seated, reach up with both hands and grasp both sides of
the headrest. You will feel the rigid frame beneath the soft head
pad. Grasping the rigid frame, tilt the headrest forward or back-
ward for maximum comfort. The headrest remains in this position
until you adjust it again.
To recline, gently pull up on the recline lever, lean back on the backrest to adjust it to the desired angle, then
release the lever. To incline to a more upright position, gently pull up on the recline lever, then pull up on
the armrests with your hands while applying slight downward pressure with your elbows, until the backrest
inclines to the desired position. Release the recline lever.
Adjust the recline angle
NOTE: Lean back against the backrest before reclining the chair.
Getting out of the perfect chair
Gently pull up on the recline lever, pull up on the armrests with
your hands while applying slight downward pressure with your
elbows, until the backrest inclines to a full upright position.
Release the recline lever. Use the arms for support when
getting up from the chair.
Adjusting the Lumbar Support
Your Perfect Chair comes with vertically adjustable built-in foam lumbar support. To adjust the lumbar support from
the default lower position:
Body pad
Spacer foam
HD lumbar support
1. Detach the top of the body pad from the chair, then fold it forward onto the chair seat. Or, remove the entire
body pad and place it flat, face down, on the floor.
2. Open the zipper on the upper back of the body pad to expose the foam. The blue High Density (HD) Lumbar
Support is installed in the lower position.
3. Remove the narrow spacer foam and move the HD Lumbar Support to the upper position.
4. Replace the narrow spacer foam below the HD Lumbar Support.
5. Close the body pad zipper.
6. Reattach the body pad to the chair.