Human Touch PC-050 Perfect Chair - Manual (Page 3)

humantouch.com
2 3
get ready Your Human Touch Perfect Chair requires some simple assembly. Just attach the
headrest/footrest frames, pads, arm caps, and head pillow, and you’re done!
3
UNPACK THE BOXES
Chair frame
Headrest frame
Slide the two ends of the footrest frame into the tube openings
in the front of the chair frame.
1. Slide the footrest frame onto the chair frame.
Using the Allen wrench and two of the provided screws,
secure each side of the footrest frame to the chair frame.
2. Install the footrest frame screws.
Using both hands, continue to pull the seat canvas all the way
forward to tightly cover the footrest frame, then secure the two
front and two side flaps, using the hook and loop fasteners.
4. Finish securing the canvas to the frame.
Footrest frame
Using both hands, pull the seat canvas forward just to the
top of the footrest frame, then secure the two flaps located
underneath the canvas to the footrest frame.
3. Attach the canvas to the footrest frame.
Arm cap (2) Head pillow
Head pad
Slide the body pad onto the lower part of the chair frame,
making sure that the frame slides into the fabric pocket located
on the bottom side of the pad.
Smooth the body pad into place, from the footrest toward
the backrest, making sure the top flap is flipped forward,
onto the body pad. The pad is automatically secured using
the hook and loop fasteners.
ATTACH THE BODY PAD
1. Slide the body pad onto the chair frame.
2. Secure the body pad.
TO AVOID DAMAGE TO THE CHAIR OR
PERSONAL INJURY, DO NOT SIT IN
CHAIR UNTIL ASSEMBLY IS COMPLETE.
Body pad
Bag contains:
Allen wrench (1),
Allen screws (12),
rubber washers (2),
flat washers (2),
hinge pin (1), clevis clip (1)