Human Touch PC-050 Perfect Chair - Manual (Page 4)

4 5
get ready
ATTACH THE ARM CAPS
1. Hook the bracket inside the front end of the arm cap into the
catch in the top of the arm frame. Lower the arm cap into position
on top of the arm frame and seat firmly with edges aligned.
2. Using the Allen wrench (provided), insert four of the provided
Allen screws into the screw holes on the underside of the armrest
and tighten them to secure the arm cap to the chair.
3. Repeat steps 1 and 2 to secure the other armrest cap to the chair.
1. Raise the chair to an upright position.
ATTACH THE HEADREST FRAME
For your convenience, and to better position the chair for the remaining assembly, use the recline lever to adjust
the chair to an upright position.
Using the provided Allen wrench and two provided screws,
secure the headrest frame to the backrest frame.
2. Insert the headrest frame into the backrest frame.
3. Install the headrest frame screws.
With the headrest frame positioned so that it can tilt forward, slide the two ends
of the headrest frame into the open tube ends at the top of the backrest frame.
1. Locate the hook-and-loop fastener that secures the brake to the
bottom of the seat canvas.
2. Open the hook-and-loop fastener to free the brake from the canvas.
3. Remove the disposable protective brake cover and discard it.
IMPORTANT: The brake shaft is lubricated. Hold the shaft at the end
to avoid handling the lubricant.
4. Tilt the chair frame forward until the end of the brake shaft is aligned
with the mounting bracket.
5. Insert the hinge pin through one of the provided flat washers,
through the mounting bracket hole, through one of the rubber
washers, through the brake shaft, through the second rubber washer,
through the other mounting bracket hole, then through the second
flat washer.
6. Install the clevis clip on the end of the hinge pin to secure it.
Brake shaft
ATTACH THE BRAKE
TO AVOID DAMAGE TO THE CHAIR OR
PERSONAL INJURY, DO NOT SIT IN
CHAIR UNTIL ASSEMBLY IS COMPLETE.
Clevis clip
Hinge pin
Flat washer
Brake shaft
Mounting
bracket
Mounting
bracket
Washer