Bluetooth wireless technology, Pairing mode, Idle mode – JK Audio RemoteMix 3.5 User Manual

Page 12: Connected mode, Bluetooth status led, When should i release the switch

Advertising
background image

Pairing Mode

In Pairing Mode, any Bluetooth wireless technlogy enabled device within

range can pair with your RemoteMix 3.5. To put the unit in Pairing Mode,

pull up the < > switch for 5 seconds while the unit is on. The blue LED will

flash rapidly at a rate of 100ms off, 100ms on. Once the pairing process is

complete the unique device ID is stored in Connection History. Subsequent

connections can be made automatically from Idle Mode.

Idle Mode

In Idle Mode, RemoteMix 3.5 searches for paired devices. To put the unit in

Idle Mode, pull up the < > switch for 2 sec when the unit is on. The blue

LED will flash at a rate of 2 secs off, 200ms on.

Connected Mode

After bonding is complete, the blue LED will flash at a slower rate of 2 secs

off, 1 sec on. The connection to that device is secure.

Bluetooth Status LED

The blue LED on the front of the unit flashes in different sequences to indicate

the current connection status. When attempting to put the unit into Idle or

Pairing mode, you should power the unit off then back on before pressing

the < > switch. If you put the unit into the wrong state due to releasing the

< > switch at the wrong time, holding the < > switch for "X" seconds will not

put it into the desired mode.

When Should I Release the Switch?

Idle Mode

Pairing Mode

Role Change

Clear

Bluetooth LED

seconds

8

Pairing to a Device with Bluetooth Wireless Technology

1. Set your Bluetooth device to Pairing Mode following the

manufacturer’s instructions.

2. On the RemoteMix 3.5, pull up on the switch < > and hold for

approximately 5 seconds. The blue LED will begin to flash rapidly as

RemoteMix 3.5 enters Pairing Mode. Pairing Mode will time out in 2 minutes.

3. On your Bluetooth device, from the list of Bluetooth connections, select

“JKRM3.5xxxx” where “xxxx” corresponds to the last 4 digits of the

unit’s serial number. Enter “Yes” when asked to bond with this device.

The pin is “0000”.

4. When bonding is completed, the blue LED will flash at a rate of 2 secs off,

1 sec on.

Bluetooth Wireless Technology

RemoteMix 3.5™

Broadcast Field Mixer

Advertising