Kessler Crane: KC-8 Cable Install - Manual

KC-8 Support Cables
Page 1
ASSEMBLY INSTRUCTIONS
STEP 1
Slide the first cable support over the aligned frame. Use a
1/4”-20 bolt and nut to secure it but do not tighten.
STEP 1A
If you have purchased the optional Tool Less Kit, slide the
first cable support over the aligned frame. Use a 1 1/2”
threaded knob to secure it. Place the female threaded
knob on the inside of the frame. Leave the knobs
loosened.
STEP 2
To attach the support cables, begin by inserting an
eyebolt into the base section opposite the handle.