Kino Flo Tegra 4Bank (TEG-400) - Manual (Page 8)

8
Dimming Control
Remote Dimmer Operation
Dimming and Color Temperature Shift
Dimming can be used to adjust the light output of the fixture. The color temperature
will shift marginally if kept to within one f-stop. Dimming beyond one f-stop may
result in a reduction of color temperature as well as a noticeable shift to magenta.
The Remote Dimmer (DIM-5) is designed to remotely dim the Tegra 4Bank.
A 15ft dimming cable is supplied with the dimmer.
Note: No batteries are required to operate the Dimmer. The power for the
dimmer is drawn from the fixture.
Insert the dimmer cable into the receptacle marked:
REMOTE DIM.
Inserting the dimmer cable will automatically disable
the onboard dimmer.
Insert the other end of the dimmer cable into the
Remote Dimmer
(DIM-5).
Manual Dimming Control
The Tegra 4Bank features a built-in dimmer control.
For full light output, turn dimmer fully clockwise.
An input jack for an optional Remote Dimmer
(DIM-5)
is located next to the lamp select switches.
Note: The ballast is designed to start lamps at any dim setting. However,
in cold temperatures, if the ballast does not start, turn off the ballast. Make sure
the dimmer is set to full and restrike. Once the lamps have come up to full
temperature after a few minutes, then dim to the desired light level.