Knog NERD 9 - Manual (Page 11)

11
SPOKE MAGNET
1. Unscrew the two halves of the magnet and mount
to a spoke on the front wheel of your bicycle. (Fig 3.4)
2. Tighten the screw using a flat head screwdriver to ensure
the magnet cannot move up and down the spoke.
TRANSMITTER UNIT
The wireless transmitter unit is designed to allow easy, fast
fitment and removal to the front wheel forks.
1. Chose a suitable location on your forks that will enable
a good line of sight between the transmitter up to the
main unit with minimal physical obstructions.
(Fig 3.5)
2. Ensure the SENSOR text is located on the wheel side
of the fork to ensure a close proximity to the spoke
magnet.
3. Ensure the arrow on the silicon housing is pointing
upward towards the main unit.
4. Pull the silicon strap around the fork and fit it over the
hook. Chose the most suitable one of the two hooks on
the strap, depending on your fork diameter.
5. Once mounted, move the transmitter unit around to
ensure the closest mounting position relative to the
spoke magnet. Optimum sensing distance between the
magnet and the transmitter housing is <5mm.
(Fig 3.6)
The silicon strap on the transmitter unit is has two
loops and is designed to accommodate fork diameters
from 20mm up to around 45mm.
Fig 3.4
Fig 3.5
Fig 3.6
11
* = N.E.R.D Wireless 12 Function Cycle Computer only