Krell 707 Evolution Addendum - Manual (Page 5)

Krell Evolution 707 Addendum v1.0
ARES Instructions March 2010
Krell Industries, LLC ▪ 45 Connair Rd, Orange, CT 06477 ▪ 203-799-9954 ▪ [email protected] ▪ www.krellonline.com
Manual / View Setup
In addition to Automatic setup, Manual/View Setup is available to manually input values
for the individual parameters or change values that the Automatic Setup has chosen. The
Manual/View Setup requires the use of a video monitor to display the Evolution 707
menu.
1. Set the video monitor to the input that the Evolution 707 video output is connected.
2. Press the menu button to enter the MAIN MENU.
3. Move the cursor to LISTENING ROOM SETUP and press enter.
4. Under Active Setup, the Cursor rests on the active MEMORY. Choose one of the
three system memories by pressing enter and scrolling up or down. Press enter to
select the desired memory. This memory selection is active and any changes will
immediately cause a change to the system.
5. Move the cursor down to EDIT CURRENT SETTINGS.
6. Press enter to enter the MANUAL SETUP MENU.
7. Configure the system as outlined in the main Owner’s Reference.
Note: If the Auto-EQ is enabled for a System memory and a manual edit is made, the
Auto-EQ is disabled and must be re-run with the new speaker configuration.
New Onscreen Display
The onscreen display has been enhanced to show memory and EQ settings.
Old Display
EQ VOLUME 090R DYN
New Display
MEM1 MOV VOL 090R DR
System Memory Field
The System Memory field displays the currently active system memory - MEM1, MEM2, or
MEM3.
Equalizer Curve Field