New Buck Corporation 42 - Manual (Page 13)

INSTALLATION OF MODEL 42 (WS)
WITH OPTIONAL WOODEN SURROUND (KIT#PAKDM42)
1. When choosing the right location for your heater and wooden surround (mantel) keep the
following in mind:
NOTE: Due to high temperatures, this heater should be located out of traffic areas and
away from furniture and draperies.
NOTE: Kit No. (PA KDM42) Optional Wooden Surround (Mantel) for Model 42 (WS).
CAUTION: THE INSTALLATION MUST CONFORM WITH LOCAL CODES OR,
IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL FUEL GAS
CODES, ANSI Z223.1/NFPA 54.
NOTE:
See page 17 for “Gas Connection” and page 18 for “Gas Pressure Check”.
WARNING: YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN
THEY ARE IN THE SAME ROOM WITH THE APPLIANCE.
DO NOT PLACE CLOTHING OR OTHER FLAMMABLE MATERIAL ON OR NEAR
THE APPLIANCE
2. Screen(s) can not be removed or altered (Position screen(s) in the closed position before
leaving heater unattended).
3. Follow instructions for assembly of (Optional) Wooden Surround (Mantel). See
instructions supplied with surround.
4. After mantel has been assembled, slide the heater from the rear into the opening of the
surround.
NOTE: Place a cloth or blanket over the front portions of the mantel as not to mar the wood.
5. Center the heater in the opening of the surround (mantel).
6. Fasten mantel to hearth by using 1/2" wood screws.
7. Insert the nine (9) wood screws provided with wooden surround through slots on nailing
flange and secure in place.
8. Position mantel and fireplace into desired location.
NOTE: Hook gas supply line into heater. Check for leaks using soap and water, not an
open flame.
NOTE: At this point, you may want to anchor the surround to the wall or floor.
Page 11