Reloop BEATMIX 2 - VirtualDJ 8 Operation Guide - Manual (Page 8)

VirtualDJ 8 – Reloop Beatmix 2 8
HotCues-Loop mode
Press the PAD MODE button A to set the PADs to Hotcues-Loop mode.
Each one of the 4 top pads assigns a Hot
Cue Point (1 to 4) or returns the track to that
Hot Cue Point.
When a Hot Cue Button is unlit, you can
assign a Hot Cue Point by pressing it at the
desired point in your track. Once it is
assigned, the Hot Cue Button will light up
blue.
Each one of the 4 bottom pads triggers a
loop of a different size (in beats), as per the
image.
Hold SHIFT down and then press one of the 4
top pads to delete its assigned Hot Cue Point.
Hold SHIFT and then use the 4 bottom pads
to set and trigger a manual loop.
Pad Nr.5 is assigned as a smart loop button.
Press the pad to set a Loop In (Entry) point.
Press the same pad again to set a Loop Out
(Exit) point and trigger the manual loop. Press
once again to exit the loop.
Use Pads Nr.6 and 7 to half and double the
size of the Loop.
Use Pad Nr.8 to trigger the last used Loop (reloop)
Sampler mode
Press the PAD MODE button B to set the PADs to Sampler mode.
Each one of the 8 pads triggers a sample
slot from the selected Sampler Bank of
VirtualDJ. If a bank has less than 9 samples,
both sides of the Beatmix 2 will control the
same samples. If a bank has more than 8
samples, the left side of the Beatmix 2 will
control samples 1 to 8 and the right side
samples 9 to 16. The Leds of the pads will be
on if a sampler slot is loaded and will blink if
plays.