Reloop BEATMIX 2 - VirtualDJ 8 Operation Guide - Manual (Page 9)

VirtualDJ 8 – Reloop Beatmix 2 9
Hold SHIFT down to receive additional
parameters of the Sampler.
Use Pads 1 to 4 to select the 4 first (default)
banks of VirtualDJ Sampler
Use Pads 4 to 8 to select the sampler trigger
mode (On/off, Hold, Stutter and Unmute)
HotCues-Sampler mode
Press both the PAD MODE buttons A and B to set the PADs to HotCues-Sampler mode.
Each one of the 4 top pads assigns a Hot
Cue Point (1 to 4) or returns the track to that
Hot Cue Point.
When a Hot Cue Button is unlit, you can
assign a Hot Cue Point by pressing it at the
desired point in your track. Once it is
assigned, the Hot Cue Button will light up
blue.
Each one of the 4 bottom pads triggers a
sample slot from the selected Sampler Bank
of VirtualDJ. If a bank has less than 9
samples, both sides of the Beatmix 2 will
control the same samples. If a bank has more
than 8 samples, the left side of the Beatmix 2
will control samples 1 to 4 and the right side
samples 9 to 12. The Leds of the pads will be
on if a sampler slot is loaded and will blink if
plays.
Hold SHIFT down and then press one of the
4 top pads to delete its assigned Hot Cue
Point.
Hold SHIFT down and use the bottom Pads
to select the 4 first (default) banks of
VirtualDJ Sampler