Revel Voice 2 - Manual (Page 10)

Ultima Voice2
Owner’s Manual
10
REAR PANEL OVERVIEW
Controls are provided on the rear panel which allow the
optimization of the Voice2 Loudspeaker response for different
loudspeaker applications and placement. Refer to the
“Loudspeaker Placement” section for more information. The
definitions below refer to Figure 4: Rear Panel on the following
page.
1. Low Frequency Compensation Switch
• Select the Flush setting (as a starting point) if the Voice2
is placed in a bookcase or wall unit.
• Select the Stand - setting (as a starting point) if the
Voice2 is placed on top of a video monitor or placed on a
shelf.
• Select the Stand + setting (as a starting point) if the
Voice2 is placed on a stand such as the optional pedestal
stand
2. Tweeter Level (dB) Switch
The tweeter output level can be adjusted in calibrated steps by -
1, -0.5, 0, +0.5 or +1 dbB
3. Input Terminals
Provides high and low-frequency connections from the
associated power amplifier(s). One pair of high-frequency
and one pair of low-frequency gold-plated binding posts are
available. The input terminals can be configured for single-
wired, bi-wired, or bi-amplified connections. Refer to the
“Making Connections” section for additional information.
4. Jumper Straps
Accommodates single-wired, bi-wired, and bi-amplified con-
nections. Two gold-plated jumper straps are installed for
single-wired connections. The jumper straps must be
removed when the input terminals are used for bi-wired or
bi-amplified connections. Refer to the “Making Connections”
section for additional information.
Note
Refer to the “Optimizing Performance” section for more information
about the Low Frequency Compensation and Tweeter Level switches.