Revel Voice 2 - Manual (Page 31)

Ultima Voice2
Owner’s Manual A-3
INSTALLING THE PEDESTAL
Step 1: Set the Voice2 Loudspeaker upside
down on a soft non-scratch surface.
Step 2: Remove the speaker from its cradle
by carefully removing the tilt adjustment
knobs and washers.
Note: Keep the knobs and washers together
as they’ll be re-used in Step 6.
Step 3: If the combination spikes/glides
were installed on the cradle, remove
the spikes, felt washers, and knurled
locking rings. If the combination
spikes/glides were not installed,
continue to Step 4.
Step 4: Remove the feet and screws
from the cradle. Put them aside.
Step 5: Install the combination
spikes/glides with the felt washers
and knurled locking rings to the
bottom of the Voice2 pedestal.
Hand-tighten the spikes firmly, but
do NOT over-tighten.
Note: If the combination spikes/glides
were not previously installed on the
cradle, the hardware will be with the
Voice2 loudspeaker hardware
accessories.
Note: Refer to page 16 for further instructions on how to install the
combination spikes/glides to the bottom of the pedestal.
Step 6: Use the four Phillips head
screws located in the Pedestal
accessories bag to install the cradle
to the top of the Voice2 pedestal.
Tighten the screws firmly but do
NOT over-tighten.
Step 7: Install the Voice2 loudspeaker onto the cradle/pedestal
assembly. Insert each threaded tilt adjustment knob first through
a metal washer and then through a felt washer before inserting it
into one of the threaded inserts toward the rear of
the Voice2 loudspeaker.
Step 8: Slide the Voice2 loudspeaker in the cradle
to adjust the tilt. When the loudspeaker has been
appropriately positioned, firmly hand-tighten
the tilt adjustment knobs to lock the loudspeaker
in place. Do NOT over-tighten.
Front & rear tilt
adjustment threaded inserts
Felt washer
Metal washer
Lockdown knob