Revel C50 - Manual (Page 9)

Figure 6. Installing feet
and spikes.
NOTE: Install the supplied
flat foot (see Figure 3 on page 6)
on the rear (center) position
of the ‘T’ base.
Figure 7. Installing the
assembled REVEL
PERFORMA PEDESTAL 2
onto the REVEL PERFORMA
C50 loudspeaker.
4. Place the stand (as shown below) and install the feet onto the
bottom of the ‘T’ base. Thread spikes about halfway into each
foot and use the wrench to tighten each one with a locking nut,
as shown in Figure 6.
5. Place your Revel Performa C50 loudspeaker as shown onto a
carpeted surface or soft towel. Attach the assembled stand with
four 8-32 x 3⁄4" flat head screws, as shown in Figure 7. Turn the
unit upright. Make final placement and spike adjustments.
REVEL PERFORMA C50
Owner’s Manual
9
7⁄ 8" max.
Lock Nut
HARD FLOORS
round end
Cover
(optional)
Foot
Spike
Lock Nut
CARPETED FLOORS
spike end
Foot
1 1⁄ 8" max.
Spike (3) Feet
(6) Screws
(for Feet)
(3) Spikes
(3) Covers
(optional)
(3) Nuts
Revel
Performa
C50
Revel Performa
Pedestal 2
(Assembled)
(4) 8-32 x 3 ⁄4"
Flat Head Screws
(Start All Screws
Before Tightening)