Sky-Watcher SYNSCAN GPS - Manual (Page 2)

2
INTRODUCTIONS FOR USE
1. If the firmware version of your SynScan® hand controller is earlier than version 3.32, you
should update the firmware to version 3.32 or later. Regarding the SynScan™ firmware
update procedure, please read the SynScan® Instruction Manual.
2. If the firmware version of the SynScan® hand controller is version 3.32 or later, your hand
controller is ready to be connected to SynScan® GPS mouse.
3. Plug the RJ-12 connector on the end of the adapter cable into the RJ-12 socket of the
SynScan™ hand controller as shown in Fig.2 .
First connect the adapter cable to SynScan® GPS mouse. (Fig. 1)
Fig. 1
Fig. 2