Sky-Watcher SYNSCAN GPS - Manual (Page 3)

3
4. Connect DC power (12V):
INSTRUCTIONS FOR USE
a) If the hand controller is connected to the mount (Fig 4) , plug the 12V DC power source
into the mount and press the mount’s power switch on (Fig. 5)
b) If the hand controller is not connected to the mount, plug the 12V DC power source
directly into the hand controller. (Fig. 6)
5. After you power on the hand controller, you will see “Initializing…” displayed on the LCD
for 2 seconds, then the hand control will find the GPS receiver module is connected and
after press ENTER, the hand control will prompt to enter the time zone and daylight saving.
6. After setting time zone and daylight saving, the LCD of the hand control will display blinking
text “GPS Fixing…” The first time you connect the SynScan® GPS mouse to the hand con-
troller, it will take at least 50 seconds to fix on the GPS signal. It may take longer, depend-
ing on the weather and environment. If it is the first time to use the GPS mouse or it has
been more than a week since last time connecting the GPS mouse, the time to fix current
coordinates will take more than 3 minutes.
Fig. 3
Fig. 5 Fig. 6
Fig. 4