Compaq Professional Workstation AP200 - Manual (Page 13)

1-1
Compaq Professional Workstation AP200 Reference Guide
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: B-CH01.DOC Last Saved On: 1/19/99 9:34 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Chapter 1
Product Features
Standard Configuration Features
■ Microsoft Windows NT Workstation 4.0 operating system software
(preinstalled)
■ One standard 400-MHz or 450-MHz Intel Pentium II processor or a
500-MHz Intel Pentium III processor featuring MMX technology with a
100-MHz system bus
■ A 512-kilobyte (K) secondary (L2) cache integrated into the processor
module (not expandable)
■ A minimum of 64 megabytes (MB) of ECC unregistered synchronous
dynamic random access memory (SDRAM) standard; expandable to
768 MB installed in dual inline memory modules (DIMMs)
■ Compaq flexible ATX chassis, configurable either as a minitower or
desktop workstation
■ One Accelerated Graphics Port (AGP) controller installed in the AGP
slot.
■ For information about the graphics controller installed on your
workstation, refer to the appropriate guide on the SmartStart for
Workstations CD under X:\DOCS\GRAPHICS, where X is your
CD-ROM drive designation. To view one of the .pdf files, use Adobe
Acrobat Reader. To install Adobe Acrobat Reader, refer to the Software
Installation Guide.
■ Three PCI expansion slots; one ISA expansion slot; one “combination”
slot for either a PCI or an ISA expansion board; and one Accelerated
Graphics Port (AGP) slot.
■ BIOS in a flash memory device supporting PCI auto-configuration
■ 200-watt surge-tolerant continuous power supply, switch-selectable for
115- and 230-VAC operation
■ One multimode, 25-pin enhanced parallel connector
■ Two RS-232C–compatible 9-pin serial connectors