SONIQ DVP720 - Manual (Page 4)

3
IMPO RTAN T SAFE TY INSTR UCTI ON
15 £Power Sources .This product should be operated only
from the type of power source indicated on the
marking label. If you are not sure of the type of
power supply to your home, consult your product
dealer or local power company. For products intended
to operate from battery power, or other sources, refer
to the operating instructions.
16 Power-Cord Protection -Power - supply cords should be
routed so that they are not likely to be walked on or
pinched by items placed upon or against them,
paying particular attention to cords at plugs,
convenience receptacles, and the point where they
exit from the product.
17 Protective Attachment Plug. The product is equipped
with an attachment plug having overload protective.
This is a safety feature. See Instruction Manual for
replacement or resetting of protective device. If
replacement of the plug is required, be sure the
service technician has used a replacement plug
specified by the manufacturer that has the same
overload protection as the original plug.
18 Power Lines . An outside antenna system should not
be located in the vicinity of overhead power lines or
other electric light or power circuits, or where it can
fall into such power lines or circuits. When in stalling
an outside antenna system, extreme care should be
taken to keep from touching such power lines or
circuits as contact with them might be fatal.
19 Overloading. Do not overload wall outlets, extension
cords, or integral convenience receptacles as this can
result in a risk of fire or electric shock.
20 Servicing . Do not attempt to service this product
yourself as opening or removing covers may expose
you to dangerous voltage or other hazards. Refers all
servicing to qualified service personnel.
OTHERS
TECHNICAL SPECIFICATIONS
Laser
Video system
Audio distortion+
noise
Frequency response
Signal/noise ratio
Channel separation
Output
Dynamic range
Wavelength 650nm/780nm
PAL/NTSC/AUTO
Audio out
(analog
audio)
Power supply
Allowable motion
temperature
Power Consumption
Dimensions
Weight 825g
DC 9V 2A
Video out
This manual is only for your reference, and any change to
the design and specifications will not be advised.
90dB
-65dB(1KHz)
80dB(1KHz)
80dB
5-35 C
10W
190X142X29mm
Output level:1V- 2V
load impedance:10k
Output level:1Vp-p+20%
Load impedance:75
imbalance, negative polarity
20Hz-20KHz+1dB
42