SONIQ DVR200 - Manual (Page 12)

11
Connection for Playback
AUDIO OUTPUT
OPTION 1: ANALOG AUDIO OUTPUT
With the supplied audio cable, connect your
recorder from the audio output jack to your TV’s
video input jack.
Audio output from your
recorder to RCAphono
left/right audio inputs
(white/red) on TV. The red plug is to the
right (marked with R),
the white plug is to the
left (marked with L).
AUDIO OUTPUT
OPTION 2: ENJOYING DIGITAL STEREO SOUND
Connect your recorder to a decoder with Dolby Digital
Processing Amplifier in two optional ways:
Option 1:
To coaxial digital output
Option 2:
To optional digital output
AUDIO OUTPUT
OPTION 3: ENJOYING DOLBY DIGITAL SURROUND WITH 5.1 CHANNELS
1. Insert each end of the channel cable i.e. FRONT RIGHT,
FRONT LEFT, SURROUND RIGHT, SURROUND LEFT,
SUBWOOFER, CENTER into the jack marked FR, FL, RS,
LS, SUB, CENTER respectively, and the other end to the
corresponding jack on your amplifier.
2. set the “DOWNMIX” to “OFF” and set “CENTER”,
”REAR”, ”SUBWOOFER” in “Audio Setup Page” menu via
the SETUP Menu.
USING 21-PIN SCART CABLE
FOR AUDIO/VIDEO OUTPUT
If scart socket is available on your TV set, you can just use
a scart cable to connect with each other.
There are socket AV-IN and AV-OUT on the rear panel of
your recorder, AV-OUT is for Audio/Video output.
Note
• Refer to the manual of the connected system.
• Turn off the power and unplug both units before setting up any connections.