SONIQ E46Z10A - Manual (Page 6)

Stand and wall-mounting instructions (optional)
How to assemble the stand
-Before attaching/detaching the stand, make sure to
turn off the TV.
-Before performing work, spread cushioning over the
base area to lay the LED TV on.
This will prevent it from being damaged.
Assembling instruction:
1) Fix the stand and the unit together with 5 screws.
Securing the TV Stand
Caution: Pulling, pushing, or climbing on the TV may cause the TV to fall. In particular,
ensure your children do not hang over or destabilize the TV; doing so may cause the TV
to tip over, causing serious injuries or death. Follow all safety precautions
For added stability, install the anti-fall device for safety purposes,
as follows.
ALTERNATIVELY
To secure the TV to the wall:
1- Put the screws into the clamps and firmly fasten them onto the wall. Confirm that the
screws have been firmly installed onto the wall.
- You may need additional material such as an anchor depending on the type of wall.
- Since the necessary clamps, screws, and string are not supplied, please purchase them
separately.
2 - Remove the screws from the centre back of the TV, put the screws into the clamps,
and then fasten the screws onto the TV again.
- Screws may not be supplied with the product. In this case, please purchase the screws
of the following specifications.
- Screw Specifications for a 46 ~ 55 Inch LED TV: M8 X L10
If you need to remove or assemble the stand please
read the following instructions.
2) To remove the stand, reverse instructions as above.
at the start of
this manual.
Screws(5-M4X10)
3 - Connect the clamps fixed onto the TV and the clamps fixed onto the wall with a strong
cable.
- Install the TV near to the wall so that it does not fall backwards.
- It is safe to connect the string so that the clamps fixed on the wall are equal to or
lower than the clamps fixed on the TV.
- Remove the cable before moving the TV.
4 - Verify all connections are properly secured. Periodically check connections for any
sign of fatigue for failure. If you have any doubt about the security of your connections,
contact a professional installer.
(optional)
Your LED TV is able to accommodate wall mounting with the use of a wall mount bracket
(not supplied with LED TV, please contact your local hardware store) and the mounting
holes on the back of the unit.
We recommend removing the TV stand prior to wall mounting the TV. Please
How to mount the LED TV on the wall
1.After detaching the stand, fasten 4 mounting screws (thread size M8X10 - not supplied!
Please contact your local hardware store) into the 4 screw holes on the rear cover, see
the figure below.
2.Fasten wall mounting bracket (Not supplied with LED TV, please contact your local
hardware store) with screws on the wall.
3.Carefully check for the strength before releasing the LED TV. NOTE: For more detailed
instructions please refer to your “after market” wall mounting instruction book.
Thread hole size – M8 x 10 depth (TV mounting screw size) on the TV.
Wall mounting instructions
see previous
page for instructions on removing the stand.
Stand and wall-mounting instructions (optional)
Wall