System connection, Headphone connection, Power cord connection – SONIQ H10 User Manual
Page 9
System Connection
System Connection
16
15
6. Headphone Connection
H10 is a HI-FI power amplifier, as well as a headphone amplifier. You can enjoy the wonderful
music with the headphone.
H10
7. Power Cord Connection
①.
② . Press the power switch to“On”, and then the machine starts working; Press the power
switch to“Off”, and then the machine will stop.
Plug the power cord to the power socket after finishing other connections.
①.Place the remote control upside down.
②.Press the sunken position, and then buckle downward.
③.Place the new battery according to the positive electrode and negative electrode directions
listed on the battery stand.
④.Push the battery stand to the original position.
⑤.Change the battery when the remote control doesn't work.
8. Installation of Remote Control Battery
9. Remote Control Operation
①.Aim the remote control directly at the remote sensor.
②.In order to avoid weakening the controlling effect, please don't lay any obstacle between the
remote control and the remote sensor.
3
V
C
R
2
0
2
5
C
R
2
0
2
5
3
V
C
R
2
0
2
5
C
R
2
0
2
5
C
R
2
0
2
5
×
1
C
R
2
0
2
5
×
1
C
A
U
T
IO
N
PLEASE REMOVE
THE BA
TTER
Y
WHEN
THE REMOTE CONTROL
IS NOT
IN USE FOR LONG
PERIOD OF
TIME
BA
TTERY TYPE:CR2025
RA
TED VOL
T
:3V/DC
Pay attention to the volume and listening time, in case that it will hurt your auditory system.
◆ Don't drop the remote control.
◆ Keep the remote control dry.
◆ Use the battery with specification of CR2025/3V.
◆ Do with the used battery (with chemical substance) properly.
①.Plug the headphone with 3.5 mm diameter to the headphone output jack in the front panel.
② .The machine will shut down the terminal signals from the left and right channels after the
headphone is plugged.
Note:
Note:
OFF
ON
TI.6AL 250V
PC-DAC
L+
L-
R+
R-
L
R
FM ANT
AUX IN
SPEAKER