SONIQ MB10 - Manual (Page 6)

9 10
Bluetooth Operation
FM OPERATION
FM Operation
BLUETOOTH OPERATION
Connection operation
Incoming calls
When you receive an incoming call on your mobile phone, music audio will
automatically mute and you will hear the ring tones through the speakers.
After you have completed your phone call, the devices are reconnected with
each other. You may have to possibly restart the playback.
In order to listen to audio from your mobile phone or other bluetooth device,
you must first pair the devices with each other.
1. Press button on the remote control to enter the Bluetooth mode.
2. When the unit is on the BT mode, the blue light flashes with 1s frequency,
then the blue light flashes quickly.
3. Turn on your Bluetooth function on your device (MP3 or telephone), and
begin to search this unit. You should select the MB10 on your searched list.
Then confirm to pair your device with this unit. If prompted, input 0000 as
password.
4. When connects successfully, the blue light will remain lit. At this moment,
you could enjoy music via BT.
To pair with another device, first, disconnect your paired device, and turn off
the BT function on your device. Once disconnect, the blue light flashes slowly.
Press the PAIR button on the remote control, the blue light flashes quickly.
Then pair with the another device as the aforementioned 4 steps.
The unit will reconnect with the last paired device.
(The BT function of the device should be on, and the unit should be turned
off in normal way, not in a way of unplugging the power supply cable without
pressing the power on/off button.)
Enter FM Function
While in operating mode, press the FM button on the remote control to enter
FM mode.
1. The range of FM frequency is from 87.50MHz to 108.00 MHz.
2. Select the band by pressing Tune+/- button: press these buttons to adjust
the frequency up or down, the frequency is 0.05MHz.
3. Press the 9
or : button to switch the next or previous band.
4. Automatically search bands: press the PLAY/PAUSE button, the system
starts to search bands from low to high frequency automatically. The
searched band are saved automatically. There are up to 60 stations can
be saved. Press this button again to stop searching.
When the signal is strong enough, the station will be played in stereo, the
display shows a stereo signal "4
". If the signal is not strong enough, you can
not see this icon.
1. Press the USB button on the remote control to exit FM status, and switch to
USB mode.
2. Press the OPT1/2 or COAX1/2 buttons on the remote control to exit FM
status, and switch to the audio input mode.
3. Press the AUX button on the remote control to exit FM status, and switch to
Audio input mode.
Select Bands
Soundtrack
Exit FM Mode
Note: Due to the different device manufacturers, models, and software
versions, a full functionality cannot be guaranteed.
Save Bands
1. Press the Tu+/- buttons to enter one frequency, 3 seconds later, the screen
will display St-XX, which means the station is saved in the current station.
2. If you want to save 99.30 MHZ in 09th cell, press 9
or : to the 09th station,
then press TU+/- button to scan to the 99.30 MHZ, seconds later, the St-09
displays on the screen and it means this station is saved in 09th cell.