Power supply – SONIQ PD70 User Manual

Page 7

Advertising
background image

-7-

C. Using the Built-in Battery

The unit has a built-in, non-replaceable, rechargeable battery. Charge the built-in battery before using it

for the first time. The normal charging time should be within 4-5 hours. The charging light will go out when

the built-in battery becomes fully charged.

To Recharge the Built-in Battery

Warnings:

• The built-in battery can only be recharged when the unit is in CHARGE mode while using the AC adaptor.

• The built-in battery cannot be recharged when the unit is in power ON mode.

• The unit should not be exposed to excessive heat such as sunshine, fire or the like.

Cautions:

• The AC adaptor included with this unit is for its use only. Do not use it with other equipment.

• When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.

• When the AC adaptor is plugged in, the apparatus is not completely disconnected from the mains, even

when the unit is turned off.

Condition and attention:

• When the built-in battery power is low, "

" will display on the screen and the unit will stop playing.

• Recharge the built-in battery when you are ready to use it again.

• While using the built-in battery, the environmental temperature should be 5°C (41°F) to 35°C (95°F).

• To get the longest service life of the built-in battery, charge at indoor-temperature.

• The built-in battery in this device may present a risk of fire or chemical burn if mistreated. Do not

disassemble, heat above 100°C (212°F), or incinerate.

• The unit should not be exposed to excessive heat such as sunshine, fire or the like.

• When discarding the unit, environmental problems must be considered and local rules or laws govering

the disposal of such products must be strictly followed.

Turning On the Unit

1. Slide the

CHARGE / STANDBY / ON switch on the left side of the unit to the ON

position.

2. The DVD logo (start-up picture) will appear on the screen.

3. After use, slide the

CHARGE / STANDBY / ON switch to the STANDBY position.

3

Slide the switch

to CHARGE

AC adaptor

4

Charging light ON

5

Recharging is

completed when

charging light

goes out

2

To DC IN

9V-12V jack

1

To AC outlet

Power Supply

Advertising