Battery installation – SONIQ QMD90B User Manual

Page 3

Advertising
background image

2

Attach the rechargeable battery pack onto the play's bottom as illustrated below:

NOTE:

This unit works either on the battery pack supplied or the AC power: unplug the AC Power adapter from the DC input jack to
work on the battery pack (after fully charged); plugging the AC Power adapter while the battery pack is attached initiates the
charging of this battery, the charge LED indicator lights up red once, and then turns off (about 5 seconds), after that, the
indicator will steady on red. When the battery is fully charged the indicator turns off again. Fully charging a run-out battery pack
may take 5 hours or longer. A fully charged battery pack can endure approximately 2.5 hours of continuous DVD playback. This
playing time may vary with the surrounding environment, the volume level of the speaker and the battery condition. It is advised
that you wait 10-20 minutes before recharging the battery pack if it has turned flat during operation.

+

+

OPEN

Insert the batteries while observing the correct (+) and (-) polarities as illustrated below.

Service life of batteries

!
!
!

A pair of new batteries normally last about one year. Service life of batteries depends largely on the frequency the remote

controller is used.

If the remote controller fails to work even when operating very near the remote sensor, the batteries should be flat, and you

need use a new pair of batteries.
Use 2 pieces of "AAA" batteries.

BATTERY INSTALLATION

BACK VIEW

SIDE VIEW

Advertising