Power supply – SONIQ QMD93B User Manual

Page 10

Advertising
background image

-9-

Turning On the Unit

1. Slide the

CHARGE / STANDBY / ON switch on the left side of the unit to the ON position.

2. The DVD logo (start-up picture) will appear on the screen.
3. After use, slide the

CHARGE / STANDBY / ON switch to the STANDBY position.

Power Supply

C. Using the Built-in Battery

The unit has a built-in, non-replaceable, rechargeable battery. Charge the built-in battery before using it for the first
time. The normal charging time should be completed within 2.25-3 hours. The charging light will go out when the
built-in battery becomes fully charged.

To Recharge the Built-in Battery

Warnings:
• The built-in battery can only be recharged when the unit is in CHARGE mode while using the AC adaptor.
• The built-in battery cannot be recharged when the unit is in power ON mode.
• Do NOT recharge the built-in battery using the car power adaptor.
• The unit should not be exposed to excessive heat such as sunshine, fire or the like.

Cautions:
• The AC adaptor included with this unit is for its use only. Do not use it with other equipment.
• When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.
• When the AC adaptor is plugged in, the apparatus is not completely disconnected from the mains, even when

the unit is turned off.

Condition and attention:
• When the built-in battery power is low, "Battery Low" will display on the screen and the unit will stop playing.
• Recharge the built-in battery when you are ready to use it again.
• While using the built-in battery, the environmental temperature should be 5°C (41°F) to 35°C (95°F).
• To get the longest service life of the built-in battery, charge at indoor-temperature.
• The built-in battery in this device may present a risk of fire or chemical burn if mistreated. Do not disassemble,

heat above 100°C (212°F), or incinerate.

• The unit should not be exposed to excessive heat such as sunshine, fire or the like.
• When discarding the unit, environmental problems must be considered and local rules or laws governing the

disposal of such products must be strictly followed.

3

Slide the switch
to CHARGE

AC adaptor

4

Charging light ON

5

Recharging is
completed when
charging light
goes out

2

To DC IN
9V-12V jack

1

To AC outlet

Advertising