SoundOff Signal Pinnacle LED - Manual (Page 6)

1. Mount fixed height brackets (See Figure 1) using supplied (3) T25 torx screws on each side. Temporarily place the lightbar in
it’s correct position on the roof of the vehicle. The bar should be positioned about the center line of the “B” pillar.
2. Based on the bar’s position, determine wire entry into vehicle. Mark location for later use. Note: Take into consideration the
location of any structural, airbag, or heating and cooling system components that can be in the way of the the wire entry point
or wire routing.
3. Install supplied vehicle specific hook brackets using supplied 1/4”-20 x 2.5 Hex Head bolts and Nylon Locking Nuts onto the bar
mounting foot as shown in Figure 2. Nut will nest into molded socket to prevent turning and improve ease of installation. It’s
recommended that you position the nut into the foot and tap it slightly with a hammer to seat it into the cast foot prior to placing
the bar on the roof. This will make installation easier.
4. Adjust fixed height bracket position on the Lightbar by loosening the (3) T25 Torx Screws on each side (See Figure 1). Be sure
that there is enough clearance between fixed height brackets and vehicle specific brackets to allow for tensioning to roof. When
the correct position is found, tighten T25 torx screws that attach fixed height bracket to lightbar base end plates.
5. Using the vehicle specific hook brackets as a template, drill 4 pilot holes using a #30 (.128 dia.) drill bit on each side of the
vehicle.
6. Secure each vehicle specific hook bracket by using the 8 supplied #8 x 1/2” Truss Head Sheet metal screws on each side.
7. Tighten each vehicle specfic hook bracket by turning the 1/4”-20 x 2.5 Hex head bolt clockwise until bar is snug and no side to
side or fore to aft movement occurs.
8. Route cables into vehicle. Use supplied rubber grommet in roof for sealing/protection of wires. It is recommended that silicone
be placed around grommet to ensure roof sealing.
WARNING - ROUTE WIRES ONLY IN LOCATIONS THAT ARE NOT SUBJECTED TO POTENTIAL WEAR. MAKE SURE TO
AVOID ROUTING WIRES IN THE DEPLOYMENT AREA OF YOUR AIR BAG. REFER TO YOUR VEHICLE’S OWNER’S
MANUAL FOR AIR BAG DEPLOYMENT ZONES.
FIXED HEIGHT BRACKETS
& HOOK MOUNTING
1/4”-20 x 2.5”
Hex Head Bolt
Vehicle Specific Hook Bracket
1/4”-20 Nylon
Locking Hex Nut
Slots for
adjustablitlity
for correct roof fit
Loosen T25 Torx Screws
to adjust brackets
FIGURE 1 FIGURE 2
Page 6