Electrical installation (continued), Nforce led interior lightbar – SoundOff Signal nFORCE Interior User Manual
Page 4
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
nFORCE LED Interior Lightbar
ENFWBF(xx)0(x) 5.14
4.
Initial Power up Test: Breakout Box needs Power (+12V to PIN 17) & Ground (PIN 4) in order to operate.
1. Insert Fuse(s) into Fuse Holder(s).
2. Observe the GREEN Data Link indicator LED on the Breakout Box; the LED will turn ON.
3. The Red indicator LED on the breakout box will be steady ON whenever any of the input wires are active
Low Power (Standby) Mode (reduced standby current)
If there is no input to the breakout box the lightbar will go into a “standby” mode. The standby mode is a low power mode that is used to extend
the life of your battery. The lightbar will awaken from the standby mode if any input is activated on the breakout box.
ELECTRICAL INSTALLATION (CONTINUED)