Stealth Cam STC-I540IR - Manual (Page 27)

STC-I540IR
www.stealthcam.net Toll Free 877-269-8490 27
Testing the Camera Coverage Area
• After mounting the camera, open front housing and slide the
power toggle switch to TEST.
• Close the front housing.
• Walk around in the front of the camera to see if you have
mounted the camera in the proper position. A green indicator
light on the front will blink when you have intruded the
coverage area.
• Adjust the camera position as needed, and repeat testing until
the desired coverage area is achieved.
• When you have completed testing the coverage area, open the
front housing and slide the power toggle switch from TEST to
ON position. This will exit the test mode. The camera will then
enter one minute count down mode. The front green LED
indicator will blink giving you one minute to leave the coverage
area. Then the camera will enter PIR detection mode.