Stealth Cam STC-I540IR User Manual
Page 28
STC-I540IR
www.stealthcam.net
Toll Free 877-269-8490
28
Using the Camera in PIR Detection Mode
•
Mount the camera to a tree or other sturdy object using either
the supplied mounting strap. (Please refer to the mounting
suggestions section in this manual)
•
Open the front housing and slide the Toggle switch from OFF
to TEST position. You will hear two short consecutive beeps
followed by a third beep.
•
Move the switch from Test to ON position to activate your PIR
mode.
•
The camera’s green LED light will begin blinking and enter
count down mode. This is your indication to leave the coverage
area within one minute.
•
After one minute, the camera will take between 1~9 pictures, or
AVI video clip based on your program settings. The camera will
then time out between 1~60 minutes also based on your
selection.
The time between motion detection and the camera taking
pictures may vary due to lighting and environment
conditions, program settings and battery power level.